Drying seeds and grains in containers
Agratechniek bv. from the Netherlands delivers measurement and control equipment to automate drying systems for seeds and grains. Use the ABC processor software to automate the drying process for every system. Agratechniek bv. works together with your supplier/manufacturer in order to run your drying process optimally.
Overview of drying systems with containers
Drying sections with fan, air distribution duct and connections to the containers.
|
|
|
|
Principle of drying section installation:
|
Stand with measurement sensor for air from the containers. A various number of containers per section is possible. |
|
Various measurements for automatic drying;
T° + RH of the suctioned air; calculation absolute humidity content (AH) |
|
|
|
Cross-section of flow fan, heating (fired directly) and fan
When the difference is too little, a lot of air is not cost effective. The air quantity will decrease. |
The T° of ingoing air is checked at the fan. This can be related to the discharging air (DeltaT°); the product can be heated up controllably and uniformly, which leads to little difference in product temperature between the lowest and highest layer. The drying process can take place in various temperature steps. The correct T° per stage will save a lot of energy.
When installing the container, the air inlet (valve or slide) is closed.
|
|
|
|
The air inlet is opened automatically and the air quantity (fan capacity) increases automatically.
|
When the seeds start to dry, the last remaining moisture with a gradually decreasing air quantity is discharged until the desired moisture content of the seeds has been achieved; the air outlet will therefore gradually close and the air quantity will decrease. |
Automation of existing systems.
Your existing systems can also be adjusted to be able to dry your seeds automatically, saving labor costs and a lot of energy. Agratechniek bv. will take care of the automation of your systems in cooperation with your own supplier/manufacturer. Existing systems can be improved easily and economically.
|
|
|
|
The heating capacity usually is variable. It can also be made variable, if needed. At the suction side of the fan and heating, a flow fan will be installed. The flow fan controls the fan. |
The fan motor is equipped with a frequency regulator for variable fan capacity. Using the correct number of revolutions, the desired air quantity will be reached. |
|
|
|
|
The outlet valve |
At the air outlet side of each container a stand with a T°+RH sensor is installed |
